Measures described here are not a counterplan to continue rally. Here introduces the tactics to settle the game as soon as possible. It is a technique to make a game in your circumstances.
In general measures against choppers, most players take the strategy that changes the Cut-rally to the Drive-rally by giving the Hcork or Fcork. But I do not like this stragety to keep rally because it forces me to suit my correspondence to the opponent.
6.1 Chopper's Rubbers and their Spin
The spin kind of a chopper is determined by their swing position and rubber type. The position is the place where the chopper was forced to select his swing direction by the dirction to which you had put back. By your chosen dirction, they have to inevitably decide the swing either the forehand or backhand or the middle position. And the ball rubbing point and the spin direction will be decided.
In addition, the spin speed is determined by the type of rubber.
Here, we will think about a reasonable attack that corresponds to the level and types of the spin.
6.2 The Basic Tactics against Middle-position Chops ★★★
The spin kinds by the opponent's chop swing using inverted rubber at the middle position are almost a ΘCut, but if the opponent used the another kind of rubber, the degree of its spin depends on the type of rubber. So, you will have to select the additional spin corresponding to the spin of each rubber.
6.3 The Basic Tactics against Forehand Chops ★★★
The spin kinds by the opponent's chop swing using inverted rubber at the forehand postion are almost ΘCurve⋅Cut, but if the opponent used the another kind of rubber, the degree of its spin depends on the type of rubber. So, you will have to select the additional spin corresponding to the spin of each rubber.
6.4 The Basic Tactics against Backhand Chops★★★
The spin kinds by the opponent's chop swing using inverted rubbers at the backhand postion are almost ΘShoot-Cut, but if the opponet used the another kinds of rubber, the degree of its spin depends on the type of rubber. So, you will have to choose the additional spin corresponding to the spin of each rubber.